beautypg.com

Festool CT 36 E-LE-AC CLEANTEX User Manual

Page 14

background image

14

CLEANTEX

GB

6.2

Switch on/off

X

Insert the plug into an earthed socket.

The switch

[1-7]

serves as an on/off switch.

Switch position "0"
Appliance socket

[1-3]

is disconnected from

the power, mobile dust extractor is switched
off.

"MAN" switch position
Appliance socket

[1-3]

is connected to the

power, the mobile dust extractor starts.

"Auto" switch position
Appliance socket

[1-3]

is connected to the

power, the mobile dust extractor starts when
the connected tool is switched on.

7

Settings

7.1

Connecting electric power tools

X

Connect the electric power tool to the ap-
pliance socket

[1-3]

.

7.2

Connecting pneumatic tools

If the compressed air module

[1-2]

(496141)

is installed, the automatic switch-on function
of the mobile dust extractor also works in
combination with pneumatic tools.

We also recommend installing the VE service
unit (495886). The service unit filters and lu-
bricates the compressed air and enables an
adjustment of the air pressure. An IAS
adapter (454757) is available to connect Fes-
tool pneumatic tools to the IAS system.
The operating pressure of the tool must be
6 bar for the automatic switch-on unit to
function correctly.

7.3

Adjusting the suction power

You can use the suction power adjuster

[1-8]

to adapt the machine suction power to differ-
ent applications.

7.4

Applying the brake

Folding out the black brake lever

[1-12]

pre-

vents the mobile dust extractor from rolling.
To achieve this, lift the front end of the mo-
bile dust extractor slightly and push the
black brake lever downwards until it latches
into place. Push the green lever

[1-11]

again

to release.

7.5

Temperature cut-out

To prevent overheating, a temperature cut-
out switches the mobile dust extractor off
when it reaches a critical temperature.

X

Switch off the mobile dust extractor and
allow to cool for about 5 minutes.

L If the mobile dust extractor will not switch

on again, please contact a Festool service
workshop.

8

Working

8.1

Handling

Hose store: after finishing work, you can
feed the suction hose through the recess

[4-

3]

and place it in the hose store. You can do

the same with the mains cable through the
other recess

[4-2]

.

SysDoc Systainer attachment system: a
Systainer can be attached to the storage
area via the two slides

[4-1]

.

8.2

Extracting dry materials

The filter element will become damp when
fluids are extracted. A damp filter element
will clog more quickly when dry materials are
extracted. Therefore, dry the filter element
before extracting dust or replace the damp
filter with a dry one.

8.3

Extracting fluids

Before extracting fluids, remove the filter or
disposal bag (see chapter 9.1). We recom-
mend using a special wet filter.

WARNING

Risk of injury from tools starting up un-
expectedly

X

Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con-
nected tool is switched off.

WARNING

Risk of injury

X

Observe the maximum connected loads
for the appliance socket (see chapter
"Technical data").

X

Make sure that the power tool is switched
off before connecting or disconnecting.

WARNING

Risk of injury

X

Make sure that the pneumatic tool is
switched off before connecting or discon-
necting.