3Com Powerware Uninterruptible Power System Prestige Series - Manual (Page 66)

Communication
60 Powerware ® Prestige Series Installation and Operator’s Manual for IBM Applications (3000 VA) Uncontrolled Copy
UPS Serial Communications Menu
With the UPS Serial Communications (Main) Menu, you can view or
select UPS communication modes, baud rates, and LAN configurations.
To change or display the current communications configuration:
1. Connect the UPS serial port to a video monitor with a serial
interface or to your computer’s serial port. If you are using
OnliNet or LanSafe software, the UPS should already be
connected to your computer.
2. Set your terminal so that it matches the baud rate of the UPS
(usually 2400 baud, 8 bits, No parity, 1 stop bit). Refer to your
terminal or operating system documentation for details on
configuring your terminal communication settings.
3. At the terminal prompt, press Control-C until the UPS Serial
Communications Menu appears.
VQT T@SD6G 8PHHVID86UDPIT H@IV
T@G@8U PQ@S6UDPI HP9@
3
@IU@S T@G@8UDPI 3 3 3
8PIUDIVPVT 9VHQ
!
"
6
7
Q
G
a
R
T
3
3
3
3
3
3
3
3
3
QPGG@9 9VHQ
TH6SU 9VHQ
6T8DD U@SHDI6G
WU U@SHDI6G
QSDIU@S 9VHQ
G6I 8PIADBVS6UDPI
T@U 76V9 S6U@
RVDU XDUCPVU T6WDIB I@X 8PIADBVS6UDPI
T6W@ 6I9 S@TU6SU
3 9 9DTQG6` 8PIADBVS6UDPI
4. Select a menu option by typing the corresponding letter or
number key. All menu selections are single keystrokes and are
not case-sensitive.
D > Display Configuration displays the current communication
settings and the new settings that you have selected prior to
saving them. The new settings are not effective until you select
save from the Main Menu.