3Com 09-1632-000 - Manual (Page 21)

Configuration Procedure 21
c Click Apply.
4 Assign an IP address to your routing ports.
a In the Basic IP section of the navigation frame, click the
IP NETaddr link.
b In the start field, choose 1.
c In the NETaddr field, enter a network address. For
example, enter:
20.1.0.1
d Click Apply.
5 Reboot the OfficeConnect NETBuilder bridge/router by
unplugging the power cord from the bridge/router then
plugging it back in. Wait for all the LEDs to turn green.
When all the LEDs are green, you will need to relogin to the
OfficeConnect NETBuilder bridge/router. Remember to use
the user name “root” and the new password you assigned
for the root user.
6 Reboot the network management station PC so that the
DHCP client in the network management station acquires a
new address from the OfficeConnect NETBuilder
bridge/router DHCP server.
7 Point the browser on the client to the new port 1 IP
address. For example, enter:
20.1.0.1
8 In the Basic IP section of the navigation frame, click the IP
NETaddr link.
a In the start field, choose 4.
b In the NETaddr field, enter IPCPA.
c Click Apply.
9 In the Dial On Demand Dynamic Dial section of the
navigation frame, click the PORT CONTrol link.
a In the start field, choose 4.
b In the CONTrol field, choose Enabled.
OC10.book Page 21 Thursday, May 13, 1999 2:33 PM