321 Studios INDUCTION HOBS 7322 230 - Manual (Page 24)

11
3)
The left display shows alternatively a [ C ] and a [ 0 ]
4)
Press the key lock until both displays indicate either [ C ] or [ - ].
5)
Take your fingers away from the keys and press again the [ - ] key during a few
seconds until some [ E ] appear.
6)
You will hear a "beep" sound and the [ E ] will blink.
7)
The [ E ] are automatically transformed into [ C ] → The configuration has been
canceled.
VI)
How to configure the hob ?
1)
Use a suitable induction pot with a minimum diametre size of 16cm.
2)
Select the heating zone by pushing the corresponding [ + ] key.
3)
Put the pot on the corresponding heating zone.
4)
Wait until [ C ] converts to [ - ]. The zone is configured
5)
Use the same procedure for each other heating zone which displays [ C ]
6)
The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
 If [ E 4 ] display persists call the After-sales Service
The hob or the cooking zone doesn’t start-up
 The hob is badly connected on the electrical network.
 The protection fuse cut-off
 The locking function is activated
 The sensitive keys are covered of grease or water.
 An object is put on a key.
The symbol [ U ] displays
 There is no pan on the cooking zone.
 The pan is not compatible with induction.
 The bottom diameter of the pan is too small.
The symbol [ C ] or [ E ] displays
 Call the After-sales Service.
One or all cooking zones cut-off
 The safety system functioned
 You forgot to cut-off the cooking zone for a long time.
 One or more sensitive keys are covered.
 The pan is empty and its bottom overheated.
 The hob also has an automatic reduction of power level and breaking Automatic
overheating
Continuous ventilation after cutting-off the hob
 This is not a failure, the fan continuous to protect the electronic device.
 The fan cooling stops automatically.