3M MP8630 - Manual (Page 21)

© 3M 1997 3M ™ Multimedia Projector MP8630
5.3 Connection to the Control Signal Terminal
ADB mouse
ADB port
D-sub 15pin (Female)
PS/2 mouse
PS/2 port
D-sub 15pin (Female)
a. Mouse emulation
(1) While the projector and computer are turned OFF, connect the projector and the mouse terminal of
computer using an appropriate cable. (PS/2, Serial or ADB)
(2) Turn ON the projector.
(3) Turn ON the computer.
(4) Select the correct mouse driver for the application. See computer's User Manual for this procedure.
Note: In some Notebook computers which have internal pointing device, mouse emulation will not work unless
the internal pointing device is disabled. In this case, disable the internal pointing device in BIOS setting.
Check the computer's manual for procedure to follow to disable internal pointing device in BIOS setting.
Caution: Turn off the power to both the projector and computer before connecting.
Connect the computer to the control terminal of the projector using the appropriate cable.
21