2. turning off the projector, 3. memory function/factory defaults – 3M MP8030 User Manual

Page 14

++ + FOCUS +++

SETUP INPUT IMAGE OPT.

RGB1
RGB2
VIDEO1

→

VIDEO2

→

TEST

PATTERN



3M 1996



Multimedia Projector MP8030

Mute: Press the MUTE

button to turn off the sound to the speakers. Press again to restore the sound.

Note

The volume level is controlled from the remote control transmitter.

Zoom: Press the ZOOM

button to adjust the image size to fill the screen. Press and hold down + or

– until the image is the desired size. If you cannot make the image fill the screen, move the projector further

back from the screen.

Focus: Press the FOCUS

button to adjust the sharpness of the image.

The following on-screen display will appear:

Press and hold down + or – until the image becomes sharp and clear.

Menu: Press the MENU

button to display the names of the system

menus across the top of the projection screen. These menus are used to adjust
the characteristics of the projected image.

Press the left/right arrow (

←

→

) to select (highlight) and display each menu.

Press the up/down (

↑

↓

) arrow or left/right (

←

→

) arrow again to select

(highlight) the desired menu option. See Section 4-5 for more about using menus.

Volume Adjustment: Use the VOLUME

button on the remote control to adjust the speaker volume.

Press ( ) to increase or ( ) to decrease the volume level. See Section 4-6 to set the volume in the Setup
menu.

4-2. Turning Off the Projector

Press and hold down the STANDBY/ON

button for one second to switch the projector to the standby

mode. The one second hold-down period is designed to avoid accidentially turning off the projector if the
standby/on button is bumped. The lamp will shut off and the green indicator on the projector panel will turn to
orange. Wait until the cooling fan motor cycles off before you press the Power Off

switch.

Note

Switching the power off before the fan has cycled off, will decrease the life of the projection lamp.

4-3. Memory Function/Factory Defaults

The MP8030 will retain all picture adjustment settings you make until you either change them again or return
all settings to the factory default.

To return picture adjustments back to the factory settings, press the RESET button on the projector control

panel

or remote control transmitter