3Com iCV-01a - Manual (Page 27)

Chapter 3: Web Interface
User Name
Assign a User Name / Account. The administrator can set up to 32 case
sensitive character names.
Password
Assign a password to the account. The administrator can set up to 32 case
sensitive passwords.
Permission
This sets the access level to individual user accounts.
Administrator: An Administrator has full access including write permission
to all menus and sub-sections. Only an Administrator can
see the User Name and IP address fields or set the camera
access Permit Hours to Operator or Viewer accounts.
Operator: The user can access all menus, but does not have
permission to amend the data fields.
Viewer: The user can only view camera within the time specified in
Permit Hours. The user does not have write permission,
can only view Camera A/B and read the Information
section.
No Access: This disables either of the above two permission levels given
to a user.
Note:
An Administrator account must be set before setting up either an Operator or
Viewer account.
IP Filter
Use this feature to ensure that the user only login from the IP address specified
here. Leave it as *.*.*.* to allow the user to login from any place.
Example:
Entering 192.168.1.* will only allow User to access from 192.168.1.xxx IP
addresses.
Max FPS
This allows the Administrator to limit the bandwidth allocated to each account.
The Administrator can set a figure of 1 to Unlimited FPS (“frames per second”).
Viewing Hours
When the Permission level is set to either Operator or Viewer, the Administrator
can set the time to which the camera can be viewed.
WebCAM - user manual -24-