8e6 Technologies ER3-100 (5K02-55) - Manual (Page 16)

8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
Install the Server into the Rack
You should now have rails attached to both the chassis and the rack unit. The next step
is to install the server chassis into the rack. Do this by lining up the rear of the chassis
rails with the front of the rack rails. Slide the chassis rails into the rack rails, keeping the
pressure even on both sides (you may have to depress the locking tabs when inserting).
Installing the Server into a Telco Rack
If you are installing the 8e6 server unit into a Telco type rack, follow the directions given
on the previous pages for rack installation. The only difference in the installation proce-
dure will be the positioning of the rack brackets to the rack. They should be spaced apart
just enough to accommodate the width of the Telco rack.