Connecting the power adapter, Connecting to your 10baset lan, Onnect – 3Com 520 User Manual
Page 28: Ing the power adapter 1-12, Connecting to your 10baset lan 1-13
1-14
C
H
A
P
T
E
R
1:
G
E
T
T
I
N
G
S
T
A
R
T
E
D
C
onnect
ing the Power Adapter
CAUTION:
First, read the section;
at the start of this manual.
Isolate the electrical mains system supply before
commencing installation.
Ensure
any o
n/off power switches
at the outlet
socket a
re set to their ‘OFF’ positions.
1
Connect the jack of the power adapter to the socket
on the rear panel of the OfficeConnect Remote (see
).
2
P
lug the mains lead
of the power adapter i
nto
a
n
adjacent electrical mains system socket
and if
necessary turn on the power at the outlet socket.
3
The OfficeConnect Remote performs a self test
and
loads the software
. During the self test
and software
loading
the ALERT and POWER LEDs flash.
Connecting to Your 10BaseT LAN
Figure 1-4
Connect The UTP Cable To OfficeConnect hub
You can connect the OfficeConnect Remote to a
hub using 10BaseT cable in the following way:
1
Connect the UTP cable (not supplied) to the 10BaseT
port of the OfficeConnect Remote.
2
Connect the other end to a 10BaseT port on your hub.
Rc.bk : RC01.FRM Page 14 Thursday, July 10, 1997 9:53 AM