Zenoah G3100T - Manual (Page 10)

10 
■ FUELING THE UNIT (OP1)
1. Remove the fuel tank cap and pour fuel into the
tank up to 80% of full capacity.
2. Fasten the fuel cap securely and wipe up any
fuel spillage around the unit.
3. Remove the oil tank cap and pour chain oil into
the tank. Fasten the cap securely.
1. Select bare ground for fueling.
2. Move at least 10 feet (3 meters) away from the
fueling point before starting the engine.
3. Stop the engine before refueling the unit.
It is very dangerous to run a chainsaw that
mounts broken parts or lacks any parts.
Before starting engine, make sure that all the
parts including bar and chain are installed
properly.
■ STARTING ENGINE
Keep clear of the saw chain as it will start
rotating upon starting of the engine.
1. Continuously push the priming bulb until fuel
comes in the bulb. (OP2)
2. Put the ignition switch to “ I ” position. (OP2)
3. While holding the throttle lever together with the
throttle interlock, push in the side button and
release the throttle lever to hold it at the start
position. (OP3)
4. Pull out the choke knob to the closed position.
(OP4)
When restarting immediately after stopping the
engine, Ieave the choke knob at the open position.
NOTE
WARNING
WARNING
WARNING
7. Operation
OP1
OP2
OP3
OP4