Yamaha RX-V795 - Manual (Page 18)

14
Caution: Plug in this unit and other components after all connections are completed.
All connections must be correct, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also refer to the owner’s manual for
each of your components.
Audio/video source equipment
● Use RCA type pin plug cables for audio/video units with the exception described later.
● The output (or input) terminals of YAMAHA audio/video units numbered as 1 , 3 , 4 , etc. on the rear panel must be connected to
the same-numbered terminals of this unit.
PHONO CD TAPE/MD DVD/LD TV/DBS VCR
IN OUT
1 3 4
AUDIO SIGNAL
FM
ANT
AM
ANT
75 Ω UNBAL.
GND
SUB
WOOFER
ON SCREEN SELECTOR
S VIDEO VIDEO REMOTE
CONTROL
IN OUT
DVD/LD
COAXIAL OPTICAL OPTICAL
DVD/LD TV/DBS CD
DIGITAL SIGNAL
IN (PLAY) OUT (REC)
EXTERNAL DECODER INPUT
MAIN CENTER SURROUND
GND
MONITOR
OUT DVD/LD TV/DBS
IN OUT
VCR
MONITOR
OUT
IN OUT
VCR
VIDEO SIGNAL S VIDEO SIGNAL
OUTPUT
LINE OUT LINE IN VIDEO OUT AUDIO OUT AUDIO OUT AUDIO IN VIDEO OUT VIDEO IN
OUTPUT
GND
VIDEO
IN
AUDIO OUT VIDEO OUT
(U.S.A. model)
Turntable
MD recorder,
Tape deck, etc.
CD player
Ⅵ
Basic connections
(*1): GND terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
: Indicates the direction of signals.
Connections
PREPARATION
(*1)
LD player, DVD player, etc. TV monitor
Video cassette
recorder
TV/Satellite tuner