Operation – Zenoah G5000AVS User Manual
Page 26
26
8. Operation
English
It is very dangerous to run a chainsaw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts
including bar and chain are installed properly.
■ STARTING ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely. (F4)
(1) Chain oil
(2) Fuel
2. Tilt the switch lever upward. (F5)
(3) Switch
3. Pull out the choke knob to the closed position. (F7)
(4) Choke knob
When restarting immediately after stopping the engine,
Ieave the choke knob at the open position.
NOTE
WARNING
F4
F5
F7
See also other documents in the category Zenoah Petrol tool:
- G3400 (8 pages)
- 3300E (11 pages)
- G3200 (5 pages)
- G3300E (16 pages)
- G621AVS (7 pages)
- G3700 (9 pages)
- G2500 (6 pages)
- G3000 (20 pages)
- G6200 (7 pages)
- G6200 (16 pages)
- G3801 (15 pages)
- G2000 (17 pages)
- G5200 (17 pages)
- G5200 (18 pages)
- G4100 (4 pages)
- G4200/G4200EZ (9 pages)
- G3800 (4 pages)
- CHAIN SAWS G2500 (18 pages)
- GZ4000 (15 pages)
- G5000 (19 pages)
- G500AVS (16 pages)
- G2500 OPS (19 pages)
- EB4401 (28 pages)
- G4500 (15 pages)
- G2000T (16 pages)
- G2000T (17 pages)
- GZ3500T (18 pages)
- GZ400 (15 pages)
- GZ4500 (15 pages)
- G415AVS (15 pages)
- G3300 (16 pages)
- KOMATSU G3800 (8 pages)
- G3100T (28 pages)
- KOMATSU G5000AVS (72 pages)
- G3300EZ (16 pages)
- G3200EZ (64 pages)
- G3800AVS (36 pages)