Zanussi ZWF1000M - Manual (Page 11)

Load the laundry
Measure out the detergent and the fabric softener
Select the required programme by means of the
programme selector dial (1)
Turn the selector dial to position to reset the
programme or to switch the machine off.
Important!
Select the spin speed or the Rinse Hold option by
pressing button 2 (only for ZWF1000M)
Open the door by
carefully pulling the door
handle outwards. Place
the laundry in the drum,
one item at a time,
shaking them out as much
as possible. Close the
door.
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment or in the appropriate
compartment if the selected programme/option it
requires (see more details in «Detergent dispenser
drawer»).
If required, pour fabric softener into the compartment
marked (the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Turn the programme selector dial to the required
programme.
The selector dial can be turned either clockwise or
anticlockwise.
At the end of the programme the selector dial must be
turned to position
, to switch the machine off.
If you turn the programme selector dial to
another programme when the machine is working, the
machine will not perform the new selected
programme.
When selecting a programme, the appliance
proposes automatically a suggested spin speed for
that programme. (See «Washing programmes» for
the maximum allowed spin speed).
Press this button repeatedly to change the spin
speed, if you want your laundry to be spun at a
different speed. The relevant pilot light illuminates.
O
O
Daily Use
Select the available options by pressing button 2
for the model ZWF180M and buttons 3 for model
the ZWF1000M
Select the Prewash option by pressing button 3
for the model ZWF180M and button 4 for the
model ZWF1000M.
Start the programme by pressing button 5 for
model the ZWF180M and button 6 for the model
ZWF1000M
When this button is pressed, the corresponding pilot
light illuminates. When it is pressed again, the pilot
light goes out.
to start the selected washing
programme.
When this button is pressed, the corresponding pilot
light illuminates. When it is pressed again, the pilot
light goes out.
Press this button
It is possible to change some options before the
programme carries them out.
Before you make any change, you must pause the
washing machine by pressing button for ZWF180M
or for ZWF1000M.
To change a running programme:
urn the programme selector dial to select the
new programme and
tart the new programme;
The washing water in the tub will be emptied out.
.
Press the button for ZWF180M or for ZWF1000M.
to interrupt a programme which is running.
Press the button again to restart the programme.
Altering an option
5
6
Change a running programme
Warning!
Interrupting a programme
5 6
• t
press button for ZWF180M
or for ZWF1000M to s
• press button for ZWF180M or for ZWF1000M
to pause the machine, turn the programme selector
dial to the new programme and press button or
again.
O,
5
6
5 6
5 6
For safety reasons you are only able to
change the programme before the heating phase has
started
11
ZANUSSI