Yamaha HTR-6060 - Manual (Page 104)

RESETTING THE SYSTEM
100
En
Use this feature to reset all the parameters of this unit to the initial factory settings.
• This procedure completely resets all the parameters of this unit including the “SET MENU” parameters. However, the advanced setup
menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on this unit.
y
To cancel the initialization procedure at any time without making any changes, press ASTANDBY/ON on the front panel to set this
unit to the standby mode.
1
Press A
STANDBY/ON on the front panel to
set this unit to the standby mode.
2
Press and hold B
TONE CONTROL and
then press A
STANDBY/ON to turn on this
unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Rotate the C
PROGRAM selector to select
“PRESET”.
4
Press B
TONE CONTROL repeatedly to
select “RESET”.
y
Select “CANCEL” to cancel the initialization procedure
without making any changes.
5
Press A
STANDBY/ON to confirm your
selection and set this unit to the standby
mode.
Resetting the system
Notes
TONE CONTROL
STANDBY
/ON
While holding
down