Yamaha HTR-6060 - Manual (Page 101)

97
En
Troubleshooting
AD
DITIONAL
INFO
RM
A
T
ION
English
■ XM Satellite Radio
If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel
display. In this case, read the cause and follow the corresponding remedies.
■ Remote control
Status message Cause Remedy
See
page
CHECK ANTENNA The XM Mini-Tuner and XM Dock are
not connected to the XM jack of this unit
or do not work properly. Check XM Mini-Tuner and XM Dock connections
and orient for the best reception level. 53
UPDATING The XM user encryption code is being
updated. Wait until the encryption code is updated. —
NO SIGNAL The signal is too weak. Adjust the orientation of the XM Mini-Tuner for the
best reception level. 53
LOADING It takes longer than four seconds for audio
or text data to be decoded. Wait until the decoding process has finished. —
OFF AIR The XM Satellite Radio channel you
selected is not currently broadcasting any
signals. Check the channel number again or select another
XM Satellite Radio channel. —
- - - The Channel Station ID (SID) is no longer
available.
- - - / - - - No artist name or song title is available.
- - - No channels are available for the selected
category. Select another channel category by pressing
4CATEGORY on the front panel (or DA-E/CAT.
l / h on the remote control) repeatedly. 55
Problem Cause Remedy
See
page
The remote control
does not work or
function properly. Wrong distance or angle. The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
27
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit. Reposition this unit.
—
The batteries are weak. Replace all batteries. —
The operation mode selector is set
incorrectly. Set the operation mode selector correctly.
When operating this unit, set it to the KAMP
position.
When operating the component selected by the input
selector button, set it to the KSOURCE position.
When operating the TV set in the DTV or PHONO
area, set it to the KTV position.
—
The remote control code was not correctly
set. Set the remote control code correctly using “List of
remote control codes” at the end of this manual.
87
Try setting another code of the same manufacturer
using “List of remote control codes” at the end of this
manual.
87
The ID code of the remote control and the
remote control ID of this unit do not
match. Match the remote control ID of this unit with the
corresponding remote control ID code.
90