ZyXEL Communications P-660HW-D - Manual (Page 3)

P-660HW-D Series Quick Start Guide
3
2 ETHERNET: Use an Ethernet cable to connect a computer to the ETHERNET port for initial configuration
and/or Internet access.
3 POWER: Use the power adaptor provided with your P-660HW-D to connect an appropriate power source
to the POWER socket. Make sure the power source is on.
4 Push in the POWER button. Look at the lights on the front panel.
• The POWER light and the DSL light blink while your P-660HW-D starts up and stay on once the DSL connec-
tion is ready. The INTERNET light is on when you are able to access the Internet and blinks when the P-
660HW-D is sending or receiving data.
• Each ETHERNET light stays on if the corresponding ETHERNET port is properly connected and blinks when
there is traffic.
If any of these lights are not on, check your connections, and inspect your cables for damage. If the lights are
still off, contact your local vendor.
2 Status Page
1 In your browser, go to http://192.168.1.1.
2 Enter the default password user to go
directly to the Status screen.
If your browser cannot find this screen,
check its security settings. See
Troubleshooting for details.