Zenoah BK4310FL - Manual (Page 9)

9
■ ATTACHING THE SHOULDER STRAP (SE1)
1. Pass the ring of the shoulder strap through the
hook(A) and fix it by the bolt securely.
2. Set the hook(B) of each shoulder strap to the D-rings
on the frame.
(A) UPPER SIDE
(B) LOWER SIDE
(1) Hook (A)
(2) Bolt (M5x12)
(3) Hook (B)
(4) D-ring
■ ATTACHING THE LINER
1. Remove the bolt located on the joint of the outer pipe.
(SE2)
2. Match the groove of the liner with the threaded hole
and fix with screw securely. (SE2)
(1) Bolt
(2) Joint
(3) Groove
3. While rotating the flexible shaft located on the
opposite end from the liner, insert the flexible shaft
into the joint until it is tightly connected. (Note that it
is normal at this time for the flexible shaft not to
project from the liner.) (SE3)
(1) Flexible shaft
(2) Liner
(3) Clutch housing
5. To connect the clutch housing to the liner, lay the liner
out straight, align the flexible shaft with the angular
hole on the side of the clutch drum, and insert the
liner into the clutch housing, being careful to make
sure that the hole on the end of the liner is facing
directly upwards. When the hole reaches a point
directly below the stopper, you will hear a clicking
sound as the stopper moves into the hole to fix the
liner into place. (SE4)
(1) Clutch housing
(2) Stopper
(3) Angular hole
(4) Hole
(5) Liner
• If you experience any difficulty in inserting the liner,
pull out the liner, rotate the flexible shaft slightly, and
4. SET UP
SE1
SE2
SE3
SE4