Zenoah BK4310FL User Manual

Page 10

Text mode
Original mode

try inserting it again.

• Once the liner has been inserted, pull on the liner to

make sure that the stopper is properly engaged.

■ ATTACHING THE THROTTLE CABLE

After fitting the wire, check if the wire sleeve is
correctly fitted to the wire stopper. It is dangerous if
the wire sleeve is out of the wire stopper because
the engine speed will not decrease even if the
throttle lever is released.

• Align the throttle cable along with the liner and tie it

with band. (SE5)

(1) Band
(2) Throttle cable
(3) Tie loosely

1. Hook the cable and into the hole of the throttle lever.

And set the cable in the lever as shown in the picture.
(SE6)

2. Attach the lever as shown in the picture and screw it

securely. (SE6)

(1) Throttle lever
(2) Hole
(3) Throttle cable
(4) Screw
(5) Nut

WARNING

4. SET UP

SE5

SE6