Yamaha CDX-393 - Manual (Page 8)

8
BASIC OPERATION
2 1
SPACE TAPE PEAK
SYNCHRO
3 INDEX
PROG CLEAR
OPEN/
CLOSE
8 7 9 0
5 4 6 + I0
DIMMER TIME
REPEAT RANDOM
SEARCH
SKIP OUTPUT LEVEL – +
STOP PAUSE PLAY
2, 3
4
1
Turn the power on.
POWER
2
Load a disc.
OPEN/
CLOSE
Disc tray
Label side up
3
Close the disc tray.
OPEN/
CLOSE
4
PLAY
Play will begin from the first track of the disc.
Display information during disc play
3 4 5 6 7 8 9 10 11 12
SINGLE
1 Shows the track number selected or being played.
2 Shows the time displays. (Refer to “Selecting time displays”
on page 10.)
3 CDX-593 and CDX-493
Shows the signal output level to an amplifier or the
headphones, adjusted by using the OUTPUT LEVEL
button.
4 Displays the CD track numbers (up to 20). After each track
is played, its corresponding number disappears so that
remaining track numbers can be seen at a glance.
Notes
• After closing the disc tray by pressing the OPEN/CLOSE
button, the display shows the total number of tracks and the
total recorded time of the disc for a few seconds.
1 2 3 4 5 6 7 8 9 10 11 12
TOTAL
• You can also close the disc tray by pressing the PLAY button
(or button on the front panel), a number button, the
RANDOM button, or by pressing the front edge of the disc
tray gently. If the tray is closed in any of these ways, play will
begin automatically, however, the display will not show the
total number of tracks and the total recorded time of the disc.
To turn off the power
Press the POWER switch again.
* If you turn on the power again with a CD in the tray, you can
start playing the CD automatically.
1 POWER