Zanussi ZWD 1251 W - Manual (Page 13)

13
11. How to change an option or
a programme during its cycle
Before you make any change, you must pause the
machine by pressing the “Start/Pause” button.
It is possible to change the temperature or any option
before the programme carries it out.
Changing a running programme is possible only by
cancelling it and selecting a new programme.
The machine will resume the cycle from the beginning
and the washing water in the tub will not emptied out.
If it is necessary to drain the water, proceed as follows:
• PAUSE the machine by pressing the “Start/Pause”
button;
• press the “Skip/Reset” button repeatedly, until only
the “Drain” light remains lit;
• press the “Start/Pause” button again.
When the water has been drained, the display shows a
blinking zero. You may now select a new programme
and press the “Start/Pause” button to start it.
12. How to cancel a programme
during its cycle
To cancel a programme that is being carried out, first
pause the machine by pressing the “Start/Pause”
button, then press the “Skip/Reset” button repeatedly,
until the display shows three blinking dashes.
13. How to open the door during
the cycle of a programme
You can open the door, after having set the machine to
PAUSE, provided the following conditions exist:
• the washing machine is not in the heating or drying
phase beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
machine, the door locked light goes off and the door can
be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the “On/Off” button.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the machine!
When you close the door and press the “On/Off” button
again, the machine will resume the programme from the
point where it had been interrupted.
14. End of programme
At the end of the programme, the machine stops
automatically, the “Start/Pause” button light goes off
and the display shows a blinking zero.
If you had selected the “Rinse Hold” option, the door is
locked (the door locked light is on), the “Start/Pause”
button light goes off, the “Rinse Hold” button light
remains lit to indicate that the water must be drained.
The display shows a blinking zero.
When the programme has been completed, a blinking
zero appears on the display and the audible signal is
given. The door locked light goes off.
Press the “Skip/Reset” button repeatedly to erase the
programme that has just been carried out. If you
omit to do this, the next time you switch the machine
on, the blinking zero will appear on the display and
you will hear the audible signal.
Note: when you switch the machine on, if you must
erase the previously performed programme, it is also
sufficient to press the “Fabrics” button and select a new
programme.
Press the “On/Off” button to switch the machine off.
The relevant light will go out.
Remove the laundry from the machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the machine.