Zanussi ZWD 1251 W - Manual (Page 11)

11
Operating Sequence
WASHING
Before the first wash, we recommend that you pour 2
litres of water into the main wash compartment
of
the detergent drawer in order to activate the
ECO valve.
Then run a cotton cycle at 95°C, without any laundry in
the machine, to remove any manufacturing residue from
the drum and tub.
Pour 1/2 a measure of detergent into the main wash
compartment
of the dispenser drawer and start the
machine.
1.Load the laundry
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2.Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out
the amount of detergent required and pour it into the
main wash compartment
.
If you wish to carry out the prewash, pour detergent into
the appropriate compartment marked
.
3.Measure out the fabric
softener
If required, pour fabric softener into the compartment
marked ,
without exceeding the «MAX» mark.
Close the drawer gently.
C0065 C0064
P0004
4. Switch the machine on
Press the “On/Off” button to switch the machine on.
The display will show three blinking dashes or a
blinking zero. The light above the button will light up.
5. Select the desired programme/
fabric
Press the “Fabrics” button repeatedly, in order to select
the desired programme/fabric. The relevant light will
light up.
The lights relevant to the phases that form the
programme will light up.
The display will show the duration of the selected
programme, calculated on the basis of the maximum
load for each type of fabric. The “Start/Pause” button
light will start flashing.
If the load of laundry to be washed is small, at the
beginning of the cycle the display will still indicate the
duration relevant to the maximum load. The duration
value will be gradually adjusted during the execution of
the cycle.
Prewash
Wash
Spin
Rinse
Drain
Drying
Cottons
Synthetics
Cotton daily
Delicate
Wool /
Handwash
Fabrics
--- ---
0
On / Off