ZyXEL Communications Powerline Ethernet Multiplug Center PLA491 - Manual (Page 9)

ENGLISH
9
2 Press the ENCRYPT button at the rear of your powerline
device for 1-2 seconds. The power ( ) light will blink as
the powerline device tries to set up a connection.
• If the power ( ) light does not blink, you have probably
pressed the ENCRYPT button for too long. Try again, press-
ing the ENCRYPT button for 1-2 seconds.
3 Repeat step 2 in this section for the other powerline
device you wish to connect. This must be done within 120
seconds of pressing the ENCRYPT button on the PLA491.
4 Check the lights on the two powerline devices. The power
( ) and HomePlug ( ) lights should be blinking.
Occasionally all lights may blink at the same time and the
HomePlug (
) light may also show red. Wait for roughly
one minute while your powerline devices connect.
• If the HomePlug ( ) lights on both powerline devices do
not light up, the powerline devices are not connected.
Repeat steps
2 and 3 in this section. If that doesn’t work,
1...2
1...2