ZyXEL Communications P-660H-TX User Manual

Page 72

P-660H-Tx v2 Support Notes

services of the line will be. After that, system will save back the correct VPI,
VCI and also services (encapsulation) type into profile of WAN interface.

• Configure the VC auto-hunting preconfigured table.

(1) Display auto-haunting preconfigured table by using command from CLI:

wan atm vchunt display

(2) Add items to the auto-haunting preconfigured table by using commands:
wan atm vchunt add bit(hex)>
wan atm vchunt save
Note: : input the remote node index 1-8
: vpi value
: vci value
: it’s a hex value, bit0:PPPoE/VC (1), bit1:PPPoE/LLC (2) ,
bit2:PPPoA/VC (4), bit3:PPPoA/LLC (8), bit4:Enet/VC (16), bit5 :Enet/LLC (32)

For example:

(1) If you need service PPPoE/LLC and Enet/LLC then the service bits will be

2+32 = 34 (decimal) = 22 (hex), you must input 22

(2) If you want to enable all service for VC hunting, the service bits will be

1+2+4+8+16+32=63(decimal)= 3f (hex), you must input 3f

Need to perform save after this by command ‘wan atm vchunt save’