Yamaha ACD1 - Manual (Page 14)

ACD1 Reference Manual 14
Panel operations
■ LCD backlight (“5. Utility” ➝ “LCD Backlight”)
This specifies the lit status of the ACD1’s LCD backlight.
■ Restricting panel operations (“5. Utility” ➝ “Panel Operation”)
Here you can turns panel operation lock on/off. By locking panel operations
you can prevent unintended operation.
• You can hold down both the [ ▲INC/YES] and [▼DEC/NO] buttons for approximately three seconds until the display indi-
cates “Unlock panel: Are you sure?”, then press the [ ▲INC/YES] button to temporarily defeat Panel Lock until the ACD1
is powered-off.
• You can also clear it by turning the Front Panel Operation setting Normal from Amp Editor.
■ Enabling scene recall operations from the panel
(“5. Utility”
➝ “Scene Recall”)
This specifies whether scene recall by operating the ACD1’s front panel will
be allowed or disabled.
• If you select “ALL” as the [Amp ID], the Scene Recall area may indicate “Some ON.” This means that scene recall is
enabled for some amplifiers but disabled for other amplifiers.
Parameter Range Explanation
LCD Backlight ON The backlight will stay lit.
Auto OFF The backlight will go dark automatically.
It will light when you perform a panel operation, and will automatically go dark ten sec-
onds afterward.
Parameter Range Explanation
Panel Operation Normal Panel lock (locking of all panel operations) will be turned off.
View Only It will be impossible to edit parameters via the panel. It will be possible to switch the
screen display.
Full Lock All panel operations other than temporarily defeating the panel lock will be disabled.
Parameter Range Explanation
Amp ID 00–39, ALL Specifies the ID of the amp for which scene recall will be enabled. If you select “ALL,”
the scene recall enable status of all amplifiers will be switched to the specified state.
Scene Recall Enable Enabled.
Disable Disabled. Scene recall can be executed from Amp Editor.
å
LCD Backlight
ON
å
Panel Operation
Normal
NOTE
å Amp ID: 01
Enable
NOTE