Zanussi ZDE 47100W - Manual (Page 10)

Problem Possible cause Remedy
Residue on inside surface of drum or
drum ribs.
Clean inside surface of drum and
drum ribs.
Conductance of water at installation
site differs from standard setting of
machine.
Re-programme standard setting for
degree of drying (see ‘Programming
options’ chapter).
Loading door does not close. Filter not in place. Install filter into place.
Drying cycle ends shortly after pro-
gramme starts.
Not enough washing loaded or wash-
ing loaded is too dry for selected
programme.
Select time programme or higher
drying level (e.g. EXTRA instead of
CUPBOARD ).
Drying cycle lasts an unusually long
time. Note: After around 5 hours the
drying cycle ends automatically.
Filter clogged. Clean filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun. Laundry must be adequately spun.
Machine settings
BUZZER SIGNAL permanent on/off
1. Turn the programme selector to any programme.
2. Press simultaneously theDELICATE and TEXTILE
buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off.
10