ZyXEL Communications Access Router P-660R-T - Manual (Page 3)

P-660R-T Series Quick Start Guide
3
• Zero Configuration
• Web Configurator Internet Access Wizard
Note: Configuration genie or Zero configuration are only able to configure the device automatically for
Internet access if you are using PPPoE, PPPoA or ENET ENCAP encapsulation with a
dynamically-assigned IP address from your ISP.
If you’re not using these Internet access settings, then use the Web Configurator Internet
Access Wizard to manually configure the device.
You will need your Internet access information such as user name and password if given by your ISP.
2.1 Configuration Genie
From the included CD, click “Multimedia Auto Provisioner” (the installation and configuration assistant) and
then click “Installation Tutorial”. After you’ve viewed the tutorial, click “Configuration Genie” at the end of the
installation tutorial or from “Multimedia Auto Provisioner” in the CD.
2.2 Zero Configuration
Launch your web browser and navigate to any web
site (for example, www.zyxel.com). The Prestige
automatically detects and configures your Internet
connection. This may take about two minutes.
If you have a PPPoE or PPPoA
connection, a screen displays
prompting you to enter your
Internet account information.
Enter the username, password
and/or service name exactly as
provided. Click Apply.
INFORMATION From ISP ENCAPSULATION METHOD YOU ARE USING
None RFC1483 in bridged mode with a dynamic IP address or
ENET ENCAP with a dynamic IP address
An IP address only RFC1483 in routing mode with a static IP address
A user name and password (and an IP address) PPPoA or PPPoE encapsulation (with a static IP address)
An IP address, subnet mask and a gateway IP
address ENET ENCAP with a static IP address