Yamaha KX-10 - Manual (Page 8)

8
B/ C/MPX FILTER indicators
L
R
dB 20 15 10 8 6 4 0 2 Ÿ 4 6
SOURCE REC
TAPE TAPE TUNING
I/NORM II/HIGH IV/METAL
MPX FILTER Ÿ B C
30
OFF/ Ÿ B/
Ÿ C/MPX
RECORDING
Preparation for recording
¶ Press the STANDBY/ON switch to turn on the power.
¶ Set your amplifier to cassette deck function mode.
1 2
)
Refer to “DOLBY NR button setting”.
DOLBY NR
3 4
‹ PLAY
REC LEVEL
10 0
REC/
PAUSE
REC
]
Play the program source to be
recorded and adjust the
recording level. See “Setting
the recording level”.
REC indicator
1
Peak level meters
AUTO TAPE
TUNING 4 MONITOR 2 3
Place the cassette on the cassette tray with
the exposed tape side facing back side of the
unit and the side to be recorded facing up. To
load the cassette tray, press the
) button.
¶ Make sure that the tape is wound to the
right-hand reel with the cassette placed on
the tray.
STANDBY/ON
switch
DOLBY NR button setting (in step 2)
Dolby noise reduction is an extremely effective method of
reducing undesirable background hiss on tapes. This unit
incorporates both Dolby B NR and the newer Dolby C NR
system. Dolby C NR is approximately twice as effective as
the earlier Dolby B NR.
Each time this button is pressed, Dolby NR switches as
follows:
B (MPX off) Recording with DOLBY B NR
Only the B indicator lights.
C (MPX off) Recording with DOLBY C NR
Only the C indicator lights.
B MPX on Recording an FM broadcast with DOLBY
B NR
B and MPX FILTER indicators light.
C MPX on Recording an FM broadcast with DOLBY
C NR
C and MPX FILTER indicators light.
OFF Recording with no noise reduction
No indicator lights.
MPX filter
FM stations transmit a 19 kHz pilot signal in addition to the
broadcast program. Sometimes this pilot signal may leak
into the audio output depending on the tuner and broadcast
conditions. This signal can cause improper operation of the
Dolby NR systems. Activating the MPX filter (B TYPE/C
TYPE MPX ON settings) will effectively remove the signal.
3
33
3
3