The rear panel – Yamaha YDG2030 User Manual
Page 7
5 – The rear panel
YDG2030
The rear panel
1
Y-485 – these bi-directional connectors are used to connect the unit on a network “chain”
using the Y-485 control protocol. They do not carry audio signals. When making a Y-485
connection, either terminal may be used for IN or OUT.
Please use digital audio cable (impedance 90 ~ 120
Ω shield type equilibrium transmis-
sion cable) for connection with periphery equipment.
Using general analog audio cable (impedance 40 ~ 50
Ω shield type equilibrium trans-
mission cable) could cause trouble such as signal reflection due to mismatching imped-
ance and transmission waveform turbulence.
Waveform turbulence is especially noticeable with long cables, and with multi cable
longer than 10 meters.
If the length of the cable is longer than 100 meters, it is recommended that it should be
terminated with a resistor matching the impedance of the cable (connect a resistor of
approx. 100
Ω between Pin 2 and Pin 3).
2
MIDI IN, OUT and THRU – these terminals are used for MIDI control of the unit. IN is
used to receive MIDI data, THRU passes along information received at the IN terminal,
and OUT transmits data originated by the unit.
3
OUTPUT (L, R) – these balanced XLR-type connectors output the signal from the unit.
4
INPUT (L, R) – these balanced XLR-type connectors are used to input signals to the unit.
5
Level switches – both the input and output connectors may be set to nominal levels of
+4dB or -20dB. When connecting other equipment, refer to the specifications of the other
units to match the signal levels correctly.
Y-485
MIDI
THRU
OUT
IN
OUTPUT
R
L
+4dB
INPUT
R
L
-20dB
+4dB
-20dB
1
3
2
4
5