Yamaha YSP-1 - Manual (Page 47)

41
MANUAL SETUP
A
D
V
ANCED
OPERA
T
ION
USER POSITION (User position)
Use to set the distance of the listening position from this
unit.
Choices: 2.0 m to 9.0 m (6.5 ft to 30.0 ft)
TO L WALL (Listening position to left wall)
If SP POSITION is set to WALL, use to set the distance of
the center of this unit from the left wall.
Choices: 0.6 m to 11.4 m (2.0 ft to 38.0 ft)
■ BEAM ADJ (Beam adjustment)
Use to manually adjust the various speaker beam angles.
We recommend that you select 5 beam mode before
adjusting these parameters.
When SP POSITION is adjusted in EASY SETUP
(page 25) or MANUAL SETUP (page 40), the factory
default value is automatically set for this parameter
(except when FOCAL LENGTH is set to CENTER).
Depending on the beam mode settings (page 34), some
speaker positions may not be available for selection. In
this case, “– –” is displayed. When using ST(STEREO)+3
beam mode, set the surround left and right signals to be
output from the front left and right speakers.
HORIZ. ANGLE (Horizontal angle)
Use to adjust the horizontal angle of beams for each
speaker.
Adjust towards – (minus) to move the direction of the
output to the left, and adjust towards
+ (plus) to move it to the right.
By adjusting the horizontal angle of the beams, you can
optimize the sound beam paths.
A test tone is automatically output.
Choices: –90° to +90°
VERTICAL ANGLE (Vertical angle)
Use this to adjust the vertical angle of beams for each
speaker.
Adjust towards – (minus) to move the angle downward,
and adjust towards + (plus) to move the angle upward. By
altering the beam path, you can optimize sound beam
angles.
A test tone is automatically output.
Choices: –90° to +90°
Initial setting: 0
2.0 m to 9.0 m
. a)HORIZ. ANGLE
b)VERTICAL ANGLE
c)DISTANCE
d)FOCAL LENGTH
[ ]/[ ]:Up/Down
[SELECT]:Enter
B)BEAM ADJ
p
p
(–)
(+)
(+)
(–)
(+) (–)
(+)
(–)
0°