ZyXEL Communications ADSL2+ Access Router P-660R-T1 v2 - Manual (Page 3)

P-660R-TxC Series Quick Start Guide
3
Note: Configuration genie and Zero configuration are only able to configure the device automatically for
Internet access if you are using PPPoE, PPPoA or ENET ENCAP encapsulation with a
dynamically-assigned IP address from your ISP.
If you’re not using these Internet access settings, then use the Web Configurator Internet
Access Wizard to manually configure the device.
You will need your Internet access information such as user name and password if given by your ISP.
2.1 Configuration Genie
From the included CD, click “Multimedia Auto Provisioner” (the installation and configuration assistant) and
then click “Installation Tutorial”. After you’ve viewed the tutorial, click “Configuration Genie” at the end of the
installation tutorial or from “Multimedia Auto Provisioner” in the CD.
2.2 Zero Configuration
Launch your web browser and navigate to any web site (for
example, www.zyxel.com). The P-660R-TxC automatically
detects and configures your Internet connection. This may
take about two minutes.
If you have a PPPoE or PPPoA connection, a screen displays
prompting you to enter your Internet account information. Enter
the username, password and/or service name exactly as
provided. Click Log on to the Internet !.
INFORMATION FROM ISP
YOU ARE USING
ENCAPSULATION METHOD MODE IP ADDRESS
None RFC1483 Bridge N/A
ENET ENCAP Routing Dynamic
An IP address only RFC1483 Routing Static
A user name and password PPPoA or PPPoE Routing Dynamic
PPPoA Bridge N/A
A user name, password and an IP address PPPoA or PPPoE Routing Static
An IP address, subnet mask and a gateway IP
address ENET ENCAP Routing Static