Controls & functions – Yamaha MY16-CII User Manual
Page 10
10
MY16-Cll
Owner’s Manual
ENGLISH
■
Panel Connectors and Indicators
1
[PRIMARY] and
2
[SECONDARY] Connectors
These are 100Base-TX Ethernet connectors.
The MY16-CII provides two Ethernet connectors to
allow construction of redundancy networks employing dual (primary and secondary) circuits. The
[PRIMARY] connector is for connection to the main circuit, while the [SECONDARY] connector is
for connection to the backup circuit.
If a failure occurs on the PRIMARY circuit (e.g. a cable failure, accidental disconnection, switching
hub failure, etc.) the SECONDARY circuit will automatically take over. Basic redundancy network
setup is described on page 13.
Use STP (Shielded Twisted Pair) cables to protect against electromagnetic interference.
3
[IN USE/CONDUCTOR] Indicators
These are the LED indicators to the left of the [PRIMARY] and [SECONDARY] connectors.
These indicators will light when power has been properly applied to the MY16-CII card. These
indicators will flash when the MY16-CII is operating as the network conductor. If an error occurs
on the connected network, both the [PRIMARY] and [SECONDARY] connector [IN USE/
CONDUCTOR] indicators will flash orange.
If both the [PRIMARY] and [SECONDARY] connector [IN USE/CONDUCTOR] indicators flash
orange, try disconnecting the corresponding Ethernet connectors. The indicator will go out if a
cable, hub, or other device connected to the network has failed. If the indicator continues flashing
orange even after the cable is disconnected, there may be a fault in the MY16-CII card itself. In this
case please refer the problem to qualified Yamaha service personnel.
4
[LINK/ACTIVITY] Indicators
These are green indicators to the right of the [PRIMARY] and [SECONDARY] connectors. The
indicator for each connector will light or flash slowly when a network cable is properly connected,
and will flash rapidly while data is being properly transferred via the corresponding connector.
5
MAC Address
The MAC (Media Access Control) address allows the CobraNet Manager to differentiate between
individual MY16-CII unuts.
Controls & Functions
1
2
3
5
4
3
4
MAC XXX *XX XX XX XX XX XX*
10
MY16-C_E.book Page 10 Monday, August 7, 2006 11:40 AM