Yamaha RX-V520 - Manual (Page 44)

40
PRESET REMOTE CONTROL
It is possible to control this unit and other YAMAHA A/V components using the remote control supplied with this unit. It is
also possible to control components from other manufacturers (or some YAMAHA components) by setting the proper
manufacturer code (a signal assigned to each manufacturer and component).
Note
• For the notes on batteries, operating distance and names and functions of the remote control, refer to each description in this manual.
Component Selector Buttons
There are eight component selector buttons. Press one of these buttons which corresponds to the component you want to
control with the remote control. For example, if you press CD on the component selector, the remote control is set to the CD
operation mode, allowing the CD player to be controlled.
5
3
2
4
7
6
AMP(TUNER)
You can perform the basic operations of this
unit.
CD
The code for a YAMAHA CD player is
factory set.
DVD/LD & DVD MENU
An LD player can be controlled in
the DVD/LD mode. A DVD player can be
controlled in the DVD/LD and DVD MENU
modes. The code for a YAMAHA DVD
player is factory set.
TAPE/MD
The code for a YAMAHA MD deck is factory
set. (The code for the YAMAHA CD recorder
and tape deck can also be set.)
VCR
A VCR can be controlled.
TV
A TV can be controlled.
CBL/SAT
A cable TV or satellite tuner can be controlled.
Notes
• The button functions on the remote control differ depending on the operation mode. Refer to the following pages for details.
• When shipped from the factory, the YAMAHA manufacturer codes listed on page 49 are set for each dial position. If unable to operate your
YAMAHA A/V component, please try using another YAMAHA code.
Controlling the Components
Connected to This Unit
■ Example: To control YAMAHA CD
player
1 Make sure that the volume is set at the
minimum level.
2 Press AMP(TUNER) on the
component selector.
3 Turn on the power.
4 Press CD on the input selector.
5 Press CD on the
component selector.
6 Press p.
Refer to “Description of Each
Mode” for the CD player
operation buttons.
7 Adjust the volume.
If you set the remote control with the manufacturer codes
listed from page i at the end of this manual, you
can control other brands of components. Refer to
“Setting the Manufacturer Code” for details.
0108V520/V420_40-46_EN 2/6/1, 2:40 PM 40