Yamaha RX-V520 - Manual (Page 26)

22
5 Play the source.
Refer to the instructions for the source component (and
“TUNING” for details).
Note
• When controlling an audio/video component (MD recorder, CD
player, DVD player, tape deck, etc.) with the remote control, press
one of the component selector buttons, (TAPE/MD, CD, DVD/
LD, etc.), which corresponds to the component you want to
control. Refer to “PRESET REMOTE CONTROL”.
6 Adjust the volume to the desired output level.
If desired, adjust BASS, TREBLE, BALANCE, etc.
These controls are only effective for the sound from the
main speakers.
• BASS controls the low-frequency response.
• TREBLE controls the high-frequency response.
• BALANCE adjusts the balance of the output volume
from the right and left main speakers.
7 Use the digital sound field processor.
Refer to “Selecting a DSP Program”.
■ To mute the sound
Use this when you want to temporarily mute audio output.
Press MUTE on the remote
control.
To restore the audio output to
the previous volume level, press
MUTE again.
Note
• During muting, “MUTE ON” appears on the display.
■ When you have finished using this
unit
Press STANDBY/ON (or POWER) to set this
unit in the standby mode.
PLAYING A SOURCE
■ Notes on the digital signal
The digital input jacks of this unit can also handle
96-kHz sampling digital signals. (To utilize this, use a
source that supports 96-kHz sampling digital signals and set
the player for digital output. Refer to the operation
instructions for the player.) Note the following when a
96-kHz sampling digital signal is input to this unit:
1. The following indication will appear on the display.
2. DSP programs cannot be selected. Sound will be output
as normal 2-channel stereo sound from only the left and
right main speakers.
Note
• If “MAIN SP” in the SET MENU is set to SMALL and
“BASS OUT” is set to SWFR or “BASS OUT” is set to
BOTH, the sound is also output from the subwoofer.
3. Adjustment of the speaker output level described on
page 37 cannot be made (except the level of the
subwoofer)
■ BGV (background video) function
The BGV function allows you to combine a video image
from a video source with a sound from an audio source.
(For example, you can listen to classical music while you
are watching a video.) This function can only be controlled
with the remote control.
Play a video source, and then select an audio source with
the input selector buttons on the remote control. The BGV
function does not work if you select the audio source with
INPUT l / h on the front panel.
PROGRAM
Front panel Remote control
or
VOLUME
Front panel Remote control
or
BASS BALANCE
– + L R
TREBLE
– +
Front panel
PCM K Z H
RX-V520 only
0104V520/V420_21-25_EN 2/6/1, 2:39 PM 22