Zanussi ZEC 30 User Manual
Page 8
8
Once the top of the panel has been correctly
positioned, fix it through the holes in the bottom
bracket, without tightening the screws (Fig. 10).
Fig. 10
Check the position again by slackening the screws
and pins then, once the best position has been
obtained, fully tighten all the fixings.
Cover the visible part of the top bracket on the
panel with plastic cover (D), inserting it in the
locations provided in the bracket.
Fig. 11
D471
D472
D
Once the door has ben correctly aligned, tighten the
holding nuts on the fixing brackets and attach the
appliance to the adjacent units and the bottom of
the work surface (Fig. 12).
Fig. 12
For a correct installation operation if the base plate
is more than 100 mm (for cavity height 820 mm) or
more than 150 mm (for cavity height 870 mm) you
must cut out the plate as shown in Fig. 13.
Fig. 13
D517
450
D593
- ZU 7120 F (20 pages)
- ZCF 310 (11 pages)
- ZU 9120 F (20 pages)
- ZBF 11420 SA (40 pages)
- ZQF 11430 DA (40 pages)
- ZFC 11 JE (16 pages)
- ZFC 11 JE (12 pages)
- ZFC 26 JE (20 pages)
- RS13FW2F (3 pages)
- ZFC 389 S (6 pages)
- 113182 (4 pages)
- BCF180DA (5 pages)
- ZBF 6114 (20 pages)
- IMF35A (2 pages)
- CIM50A3 (5 pages)
- CIM29A3 (2 pages)
- U28059 ZFC 177 C (16 pages)
- TRF183AE (4 pages)
- ZRB 2630 W (20 pages)
- TRF132A (4 pages)
- Z1921/8 FFA (20 pages)
- 726690 (5 pages)
- CIM67A (5 pages)
- ZFC 35 SI (12 pages)
- ZUT 6246 (16 pages)
- ZEF 90 W (16 pages)
- U30456 ZFC 50 JC (8 pages)
- ZRB 2725 W (20 pages)
- RCSF3M22 (4 pages)
- ZFC 632 WAP (8 pages)
- ZFC 321 WB (12 pages)
- CIM143WS3 (2 pages)
- ZV 45 RAL (16 pages)
- ZERT 2170 (16 pages)
- IMF250AB20 (2 pages)
- 728636 (4 pages)
- ZEF 55 W (16 pages)
- ZRB 2825 W (20 pages)
- ZRD 1843 (20 pages)
- ZUT 125W (20 pages)
- ZCF 94 C (16 pages)
- ZRB 2530 S (20 pages)
- ZUC 053W (16 pages)
- ZNB 404 W (24 pages)