Zanussi ZEC 30 - Manual (Page 6)

6
Location
This appliance is designed to be built-in to a space
having the dimensions given in Fig. 2.
Fig. 2
The height of the appliance can be altered if
required by means of adjustable feet situated at its
base (Fig. 3).
Fig. 3
100-170
446
820-870
547 550
450
820 870
D506
D507
Door reversibility
Remove the two screws which fix the upper hinge to
the door.
Carefully lean the appliance on its back and remove
the plastic insert (Fig. 4).
Fig. 4
Remove the two screws which fix the lower hinge to
the door.
Remove the four screws which fix the lower hinge
to the base of the appliance and remove the hinge
itself; be very careful to recover all the screws.
Remove the four screws that fix the upper hinge to
the appliance and remove the hinge itself.
Take the hinge removed from the upper part of the
appliance on the opposite side (see Fig. 5), and,
using the screws removed from the lower part, fix it
to the base of the appliance itself.
Remove and refit the other hinge on the upper part
of the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges (Fig. 5).
Fig. 5
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and
fit the insert supplied with the appliance on the
opposite side.
D447
D510