Zenith HEALTHVIEW H20J55DT - Manual (Page 10)

Page 10 206-4065
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN
Antenna
Cable
Typical
TV Back
M.P.I.
In
Out Audio Video
3 4
VCR Back
VCR Back AV Panel
output
switch
A/V cables
not included
with TV
RF Coaxial Wire
(75 ohm)
Antenna
Hook Up an Off Air Antenna with VCR
1
2
Locate the Antenna/Cable In jack on the
back of the VCR.
Connect the antenna that runs from the wall
jack directly to this jack, according to the
connection diagram shown to the right.
Make the VCR to TV connections as indicated
in the illustration.
If you have a 75 ohm RF cable, then you
don’t need any adapters!
A 300 to 75 ohm adapter is not included
with the Zenith TV.
Over-the-Air Antenna with VCR
Connect an over-the-air signal source to the VCR and TV
3
No A/V cables are
included with the TV.