Yamaha DSP-A492 - Manual (Page 24)

24
Notes on using the input selector buttons
DSP-A592
● Note that pressing on each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
* To select the source connected to the VIDEO AUX
terminals on the front panel, press VIDEO AUX.
● The selection of TAPE (MD) MON cannot be canceled by
pressing another input selector button. To cancel it, press
TAPE (MD) MON again so that “TAPE MONITOR”
disappears from the display.
When you select a button other than TAPE (MD) MON,
make sure that “TAPE MONITOR” is not illuminated on the
display.
● If you select the input selector button for a video source
without canceling the selection of TAPE (MD) MON, the
playback result will be the video image from the video
source and the sound from the audio tape (or MD etc.).
● Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
DSP-A492
● Note that pressing on each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
● The selection of TAPE (MD) MONITOR cannot be canceled
by pressing another input selector button. To cancel it,
press TAPE (MD) MONITOR again so that “TAPE MON”
disappears from the display.
When you select a button other than TAPE (MD)
MONITOR, make sure that “TAPE MON” is not illuminated
on the display.
● If you select the input selector button for a video source
without canceling the selection of TAPE (MD) MONITOR,
the playback result will be the video image from the video
source and the sound from the audio tape (or MD etc.).
● Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
DSP-A592 only
To listen to a decoded source using Dolby
Digital (AC-3) by reproducing the signals input
to the 6CH DISCRETE INPUT DVD/LD TV/DBS
terminals of this unit.
In step 3, select TV/DBS or DVD/LD, and then press the
2CH/6CH button so that “6ch” appears on the display.
Discrete signals from the unit connected to the 6CH
DISCRETE INPUT DVD/LD TV/DBS terminals of this unit are
selected as the input signals.
To cancel it, press the 2CH/6CH button again or select another
input source.
Note for reproducing discrete signals with Dolby Digital
(AC-3) decoded:
1. Your speaker system must include a center speaker.
2. Your speaker system must include a subwoofer.
* Connect a subwoofer which has a built-in amplifier to the
SUBWOOFER OUTPUT terminal of this unit.
* You can do without using a subwoofer. If you do so, you
should make a setting for distributing signals at the LFE
channel to the right and left MAIN output terminals on the
Dolby Digital (AC-3) Decoder unit.
For details, refer to the owner’s manual for the Dolby
Digital (AC-3) Decoder unit.
Notes
● When you switch to the “6CH” mode, the built-in Digital
Sound Field processor will not work and adjustment of delay
time cannot be made.
● Switching this unit to the “6CH” mode will input no signal to
this unit if there is no connection to the 6CH DISCRETE
INPUT DVD/LD TV/DBS terminals of this unit.
2CH/6CH