Yamaha RX-V1070 - Manual (Page 13)

Turn up the volume by using the remote control
transmitter. You will hear a test tone (like pink noise)
from the left front speaker, then the center speaker,
then the right front speaker, and then the rear
speakers, for about two seconds each. The display
changes as shown below.
* If your monitor is on, the state of test tone output is also
shown by an image of audio listening room on the
monitor’s screen.
* The test tone from the left rear speaker and the right rear
speaker will be heard at the same time.
13
For detailed information on the remote control transmitter, refer to “REMOTE CONTROL TRANSMITTER” on page 25.
Select the center mode according to your speaker
configuration.
(Refer to “SPEAKER CONFIGURATION” on page 6.)
On the feature of each mode, refer to the “Note” shown
below.
Note
In step 8, when you select the center mode, note the following.
For 5 speaker configuration)
NORMAL: Select this mode when you use a center speaker
that is smaller than the front speakers. In this
mode, the bass tone will be output from the front
speakers.
WIDE: Select this mode when you use the center speaker
approximately same sized as the front speakers.
For 4 speaker configuration)
PHANTOM: Select this mode when you do not use the center
speaker. The center sound will be output from the
left and right front speakers.
7
8
9
10
Illustrations: RX-V1070
Parts in shaded areas ( ) are not present on RX-V870.
10
9
7
10
7
8
ou
CENTER
MODE
NORMAL
WIDE
PHANTOM
NORMAL
Flashes continuously.
Front (L) Center
Rear
(L and R)
Front (R)