Yamaha RX-V1070 - Manual (Page 10)

10
ABOUT THE ACCESSORY TERMINALS
AC OUTLETS
(U.S.A., Canada and General models)
......... 2 SWITCHED OUTLETS and 1 UNSWITCHED OUTLET
(Australia model) ...................................1 SWITCHED OUTLET
Use these to connect the power cords from your components
to this unit.
The power to the SWITCHED outlets is controlled by this unit’s
POWER switch or the provided remote control transmitter’s
POWER key. These outlets will supply power to any
component whenever this unit is turned on.
The power to the UNSWITCHED outlet can not be controlled
by this unit’s POWER switch or the provided remote control
transmitter’s POWER key.
<
U.S.A. and General models
>
The maximum power (total power consumption of
components) that can be connected to the SWITCHED AC
OUTLETS is 100 watts.
The maximum power (total power consumption of
components) that can be connected to the UNSWITCHED AC
OUTLET is 200 watts.
<
Canada model
>
The maximum power (total power consumption of
components) that can be connected to the SWITCHED AC
OUTLETS is 120 watts.
The maximum power (total power consumption of
components) that can be connected to the UNSWITCHED AC
OUTLET is 180 watts.
<
Australia model
>
The maximum power (total power consumption of
components) that can be connected to the SWITCHED AC
OUTLET is 100 watts.
REMOTE CONTROL (PHONO) connector
If you have a YAMAHA turntable with the terminal for remote
control, connect it to this connector by using the cable provided
with the turntable. This connection allows you to control the
turntable from the provided remote control transmitter.
GND terminal (For turntable use)
Connecting the ground wire of the turntable to this terminal will
minimize hum, but in some cases better results may be
obtained with the ground wire disconnected.
FRONT OUT terminals
These terminals are for front-channel line output. Leave the
jumper bars connected to FRONT IN terminals when you use
the built-in amplifier.
However, if you drive front speakers with an external stereo
power amplifier, remove the jumper bars and connect the input
terminals of the external amplifier (MAIN IN or AUX terminals
of a power amplifier or an integrated amplifier) to these
terminals.
FRONT IN terminals
These terminals are for line input to the built-in front-channel
amplifier. Leave the jumper bars connected to FRONT OUT
terminals when you use the built-in amplifier.
However, if you drive front speakers with an external stereo
power amplifier, remove the jumper bars.
REAR OUT terminals
These terminals are for rear-channel line output. If you use the
built-in amplifier, there is no connection to these terminals.
However, if you drive rear speakers with an external stereo
power amplifier, connect the input terminals of the external
amplifier to these terminals.
If you use the built-in amplifier and the external power amplifier
at the same time, the sound will be output only through the
external one.
CENTER OUT terminal
This terminal is for center-channel line output. There is no
connection to this terminal when you use the built-in amplifier.
However, if you drive a center speaker with an external power
amplifier, connect the input terminal of the external amplifier to
this terminal.
If you use the built-in amplifier and the external power amplifier
at the same time, the sound will be output only through the
external one.
LOW PASS terminal
This terminal is for output to a mono amplifier driving a
subwoofer. Frequencies above 200 Hz are filtered out so that
only the bass range remains.