Yamaha DSP-A5 - Manual (Page 26)

24
Canceling the Sound Effect (turning
off the effect speakers)
Press EFFECT to cancel
the sound effect and
monitor only the main
sound.
Press EFFECT again to turn the
sound effect back on.
y
If the selector dial is set to a position other than the DSP/TUN
position, first press DSP and then EFFECT on the remote control.
Notes
• If you turn off the sound effect when Dolby Digital or DTS is
decoding, the sounds of the center and rear channels are mixed
and output from the main speakers.
• If you turn off the sound effect when Dolby Digital or DTS is
decoding, it may happen that the sound is output faintly or not
output normally, depending on the source. In this case, turn sound
effect back on.
Front panel
or
Remote control
DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT
0104DSP-A519-24_EN 2/29/0, 4:54 PM 24