Yamaha NS-125F - Manual (Page 3)

E-
3
English Connecting Your
Speakers
Always turn off your amplifier or receiver
before making any connections.
■ Preparing Your Speaker Cables
Carefully remove 10 mm (3/8 ”) of insulation
from both ends of your speaker cables and twist
the bare wires tightly, as shown.
■ Hookup
■ Using a Banana Plug
1. Remove the speaker terminal cover by
gently pulling it toward you.
2. Tighten the terminal knob.
3. Simply insert the banana plug into the
terminal.
Good No Good
10 mm
(3/8 ”)
SPEAKERS
A
B
L R
+ + – –
+
–
Loosen
Tighten
Amplifier or
receiver
Notes:
• Make sure that the bare wires are not touching each
other as this could damage the speaker and
amplifier.
• Connect one speaker to the left terminals of your
amplifier, and another speaker to the right
terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
1
3
2
Banana Plug
0101NS-125F_en.fm Page 3 Thursday, September 2, 2004 5:25 PM