Zanussi DES 959 - Manual (Page 17)

17
8b. Setting and starting the
programme with "delay start"
Once a programme and required options
have been selected (see point 8a.) to use "delay
start" proceed as follows:
Press the "delay start" push button. The
digital display will show "h 0". Press the
button again to select the number of hours
by which you wish to delay the programme
start (up to a maximum of 12 hours).
The delay start will not modify the settings
made previously .
To set the time setting to zero press the
"delay start" push button until "h 0" appears
in the digital display.
Press the "programme start" push button.
The digital display shows the delay time
required before the start of the programme.
The start of the countdown will be confirmed by
the flashing "h" in the digital display.
Once the delayed time has elapsed the
programme will start automatically.
9. To cancel a programme in
progress
Press and keep pressed the "programme start"
push button for at least 3 seconds to cancel a
programme in progress.
Three horizontal lines will appear in the digital
display, this means that the dishwasher has
returned to setting mode and is now possible to
select a new washing programme.
10. At the end of the washing
programme
The dishwasher will automatically stop and
an intermittent audible signal informs you
that the programme has ended.
Three horizontal lines will appear in the
digital display and all the indicator lights of
the phases will turn off.
To return to setting mode press any of the
push buttons or switch off and then switch
on the dishwasher.
The On/Off indicator light remains on until
the On/Off push button is depressed.
Open the door and wait a few minutes
before removing the dishes; in this way
they will be cooler and the drying will be
improved.
Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
Important!
In general it is not advisable to open the
door while the machine is working; if the
door is opened however, a safety device
ensures that the machine stops.
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished, as
steam may escape.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
SEQ33en