Yamaha MDX-E100 - Manual (Page 17)

E-17
English
MOVE
This function lets you change the position of any track.
When you move tracks, all tracks are automatically
renumbered.
Example: Moving track 2 to the track number 4
1 Use $ or › to select the track you want to
move.
2 Press EDIT repeatedly to display “Move ?”,
then press SET/ENTER .
3
Use $ or › to select the track’s
destination (new track number).
4 Press SET/ENTER .
“Complete” appears momentarily in the display.
COMBINE
This function lets you combine two consecutive tracks
into one. After you combine the tracks, the total number
of tracks decreases by one and the tracks following the
combined tracks are renumbered.
Example: Combining tracks 2 and 3
1
Press & to stop playback.
2 Use $ or › to select the second track of
the two you want to combine.
3 Press EDIT repeatedly to display
“Combine ?”, then press SET/ENTER .
“Check” appears momentarily, then the MD recorder plays
the 4 seconds before and after the point where the tracks
will be connected. “(track number) + (track number) OK?”
appears in the display.
4 Press SET/ENTER again.
The tracks are combined and “Complete” appears
momentarily.
Destination Selected track
Before
combining
Before
moving
After
moving
1 2
A B D E C
3 4 5 6
1 2
A C B E D
3 4 5 6
ANALOG
DIGITAL
OPT.123
COAX. DISC TRACK
TOTAL
REMAIN
1 2
A B D E C
3 4 5 6
1 2
A B+C D E
3 4 5
After
combining
Disc or Track Title Erase
This operation lets you erase the title of the disc or the
title of tracks on a disc. The title of the disc can only be
erased during the stop mode, however, the title of the
track can be erased during play or stop mode.
To erase a disc title
1 Press & to set this unit to stop mode.
2 Press EDIT repeatedly to display “Title
Erase?”, then press SET/ENTER .
“Disc Title” and “Erase OK?” appear alternatively in the
display.
3
Press SET/ENTER again.
The disc title is erased and “Complete” appears
momentarily.
To erase a track title
1
Use $ or › to select the track with the
title you want to erase.
2 Press EDIT repeatedly to display “Title
Erase?”, then press SET/ENTER .
“Track Title” and “Erase OK?” appear alternatively in the
display.
3
Press SET/ENTER again.
The track title is erased and “Complete” appears
momentarily.
Notes
• Note that the DISC and TRACK indicators appear in the
display when “Title Erase” is displayed to distinguish
between the two operations.
• To avoid mistakes when erasing the disc or track names,
press DISPLAY repeatedly until the title display screen
appears so that titles can be confirmed beforehand.