Zenoah G6200 User Manual

Page 13

G6200

GB-13

■ PERIODICAL SERVICE POINTS

1. Cylinder fins

Dust clogging between the cylinder fins will cause overheat-
ing of the engine. Periodically check and clean the cylinder
fins after removing the air cleaner and the cylinder cover. When
installing the cylinder cover, make sure that switch wires and
grommets are positioned correctly in place.

NOTE

• Be sure to block the air intake hole.

2. Fuel filter

(a) Using a wire hook, take out the filter from the filler port.

(b) Disassemble the filter and wash with gasoline, or replace

with a new one if needed.

NOTE

• After removing the filter, use a pinch to hold the end

of the suction pipe.

• When assembling the filter, take care not to allow fil-

ter fibers or dust inside the suction pipe.

3. Oil tank

Drain the oil tank and clean the inside with gasoline.

4. Spark plug

Clean the electrodes with a wire brush and reset the gap to
0.65 mm as necessary.

5. Sprocket

Check for cracks and for excessive wear interfering with the
chain drive. If the wear is considerable, replace it with new
one. Never fit a new chain on a worn sprocket, or a worn chain
on a new sprocket.

6. Front and Rear dampers

Replace if adhered part is peeled or crack is observed on the
rubber part. Replace if the inside of the rear damper metal has
been beaten by the stopper bolt and the clearance of the metal
increased.

Fuel filter

(1) Weight
(2) Filter
(3) Strainer
(4) Retainer

0.6 ~ 0.7 mm

NGK
BPMR7A