E “ipod” section in, E 102, Hdmi ■ ipod – Yamaha RX-V861 User Manual

Page 106: Auto setup

102

Troubleshooting

■ HDMI

■ iPod

In case of a transmission error without a status message appearing in the front panel and in the OSD, check the connection to your iPod
(see page 23).

■ AUTO SETUP

Before AUTO SETUP

Error message

Cause

Remedy

See

page

DEVICE OVER

The number of the connected HDMI
components is over the limit.

Reduce the number of the connected HDMI
components.

—

HDCP ERROR

HDCP authentication failed.

Check that the connected HDMI components support
the HDCP copy protection standards.

—

Out of Res.

Out of resolution. The connected video
monitor does not accept the output video
signals at the HDMI out jack.

Set “HDMI UP SCALING” to “THRGH” or “480p”
(or “576p”).

Note

Status message

Cause

Remedy

See

page

This unit is in the middle of recognizing
the connection with your iPod.

This unit is in the middle of acquiring
song lists from your iPod.

Connect error

There is a problem with the signal path
from your iPod to this unit.

Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit.

Try resetting your iPod.

—

Unknown iPod

The iPod being used is not supported by
this unit.

Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.

—

iPod connected

Your iPod is properly stationed in a
Yamaha iPod universal dock (such as the
YDS-10, sold separately) connected to the
DOCK terminal of this unit, and the
connection between your iPod and this
unit is complete.

Disconnected

Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-10 sold
separately) connected to the DOCK
terminal of this unit.

Station your iPod back in a Yamaha iPod universal
dock (such as YDS-10 sold separately) connected to
the DOCK terminal of this unit.

Unable to play

This unit cannot play back the songs
currently stored on your iPod.

Check that the songs currently stored on your iPod
are playable.

—

Store some other playable music files on your iPod.

—

Error message

Cause

Remedy

See

page

Connect MIC!

Optimizer microphone is not connected.

Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.

Unplug HP!

Headphones are connected.

Unplug the headphones.

—