Yamaha RX-V390RDS - Manual (Page 14)

14
1
Set to the “
∞
” position.
2
Turn the power on.
3
Select the desired input source by using the input
selector buttons.
(For video sources, turn the TV/monitor ON.)
* The name of the selected input source will appear in
the display.
4
Select the front speakers to be used.
* If you use two front speaker systems, press both the A and
B switches.
5
Play the source. (For detailed information on the
tuning operation, refer to page 17.)
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE
controls, etc. (refer to page 16) and use the digital
sound field processor. (Refer to page 27.)
Notes on using the input selector buttons
● Note that pressing on each input selector button selects
the source which is connected to the corresponding input
terminals on the rear panel.
● The selection of TAPE MONITOR or VCR MONITOR
cannot be canceled by pressing another input selector
button. To cancel it, press it again.
● In step 3, if two or more program sources are selected at
the same time, be sure to remember the priority order of
the input sources.
Priority order of sources: 1) TAPE MONITOR, 2) VCR
MONITOR, 3) LD/TV, TUNER, CD or PHONO.
* If you select LD/TV, TUNER, CD or PHONO, be sure
that neither TAPE MONITOR nor VCR MONITOR have
been selected.
* If you select TAPE MONITOR and VCR MONITOR and
another input selector button at the same time, the
playback result will be the video image from the VCR
and the sound from the audio tape.
* If you select both LD/TV and TAPE MONITOR at the
same time, the playback result will be the video image
from the LD player and the sound from the audio tape.
* Once you play the LD player, its video image will not be
interrupted even if other input selector buttons except
VCR MONITOR are selected.
To turn off the power
Press the POWER switch again.
BASIC OPERATIONS
TO PLAY A SOURCE
SPEAKERS
A B
ON
OFF
ON
OFF
VCR
MONITOR LD/TV
TAPE
MONITOR TUNER CD PHONO
COPY
3 1, 6 2
4 7 7
POWER