Yamaha DSP-AX863SE - Manual (Page 37)

35
En
Optimizing the speaker setting for your listening room (YPAO)
PRE
P
ARA
T
ION
English
■ If an error screen appears
Press 9k / n / l / h to select “RETRY” or
“EXIT” and then press 9
ENTER.
The following display is an example when “E-9:USER
CANCEL” appears in the OSD.
Choices: RETRY, EXIT
• Select “RETRY” to retry the “AUTO SETUP”
procedure.
• Select “EXIT” to exit from the “AUTO SETUP”
procedure.
y
If “E-5:NOISY” appears, “PROCEED” also appears in the
choices. When you select “PROCEED”, this unit continues the
measurements and settings, but the settings may not be optimal.
■ If “WARNING” appears
When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” appears in the
top result display. Check the warning messages to correct
your speaker settings.
Warnings differ from errors in that warnings do not cancel the
“AUTO SETUP” procedure.
1
Make sure the pointer is pointing at
“WARNING” and then press 9
ENTER to
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
2
Press 9l / h repeatedly to toggle between
the warning displays.
y
• For details about each warning message, see the “AUTO
SETUP” section in “Troubleshooting” on page 103.
• When the corresponding warning message is not
applicable to a speaker, “––” is displayed instead.
• If “SWFR: TOO LOUD” or “SWFR: TOO LOW” appears
in the “W-3: LEVEL ERROR” display, adjust the volume
level of the subwoofer(s).
3
Press 9
ENTER to return to the top result
display.
ERROR
. E-9:USER CANCEL
Don't operate
any function
>RETRY EXIT
[ ]/[ ]:Select
[ENTER]:Enter
[ [
Note
AUTO SETUP
RESULT
. WARNING(3)
>SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Detail
SP : 3/4/0.1
DIST: 4.50/5.30m
LVL : -9.0/+6.5dB
WARNING
W-1:OUT OF PHASE
Reverse Channel
FL
--
CENTER
PL
PR
SL SR
SBL SBR
[ ]/[ ]:Select
[ENTER]:Return
[ [