Yamaha DSP-AX863SE - Manual (Page 106)

104
En
Troubleshooting
After AUTO SETUP
• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
• If a warning message “W-1”, “W-2”, or “W-3” appears, corrections are made, but they may not be optimal.
• If an error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.
Warning message Cause Remedy
See
page
W-1:OUT OF PHASE Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly. Check the speaker connections for proper
polarity (+ or –). 14
W-2:OVER 24m (80ft) The distance between the speaker and the
listening position is over 24 m (80 ft). Bring the speaker closer to the listening
position. —
W-3:LEVEL ERROR The difference of volume level among
speakers is excessive. Readjust the speaker installation so that all
speakers are set in locations with similar
conditions. —
Check the speaker connections. 14
Use speakers of similar quality. —
When “SWFR: TOO LOUD” or “SWFR:
TOO LOW” appears in the result screen, the
output volume of the subwoofer. 31
W-4:CHECK PRNS “EXTRA SP ASSIGN” is set to
“PRESENCE”, though the presence channel
signals are not detected. Check the presence speaker connections. 14
Set “EXTRA SP ASSIGN” to a setting other
than “PRESENCE”. 32
Notes