Yamaha HTR-5790 - Manual (Page 27)

23
CONNECTIONS
PRE
P
ARA
T
ION
If you are using 6 ohm speakers, set the impedance to 6
ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1
On the front panel, while pressing down
SPEAKERS A, press STANDBY/ON.
“SP IMP.SET” appears on the front panel display for
a few seconds, then “Minimum 8ohms” appears.
2
Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
y
You can also use SP IMP.SET (see page 57) to set the speaker
impedance.
When all connections are complete, turn on the power of
this unit.
1
Press STANDBY/ON (SYSTEM POWER on
the remote control) to turn on the power of
this unit.
2
Turn on the video monitor connected to this
unit.
Speaker impedance setting
CAUTION
SPEAKERS
A
STANDBY
/ON
S P I M P . S E T
M i n i m u m 8 o h m s
Turning on the power
PRESET/TUNING
EDIT
FM/AM A/B/C/D/E PRESET/TUNING
INPUT MODE TONE CONTROL MULTI CH INPUT STRAIGHT
EFFECT
MEMORY
MAN'L/AUTO FM
TUNING MODE
AUTO/MAN'L MONO
VOLUME
PROGRAM INPUT
STANDBY /ON
OPTIMIZER MIC
PHONES
SILENT CINEMA
SPEAKERS A B
OPTICAL R AUDIO L VIDEO S VIDEO
VIDEO AUX
1
PHONO
POWER SLEEP
CLEAR LEARN
STANDBY
TRANSMIT RE–NAME
INPUT MODE SYSTEM
V-AUX
DTV
POWER
REC
POWER AMP
AV TV
DVR/VCR2 VCR 1 DVD
SELECT
CBL/SAT MD/TAPE CD-R
TUNER MULTI CH IN CD
1
(U.S.A. model)
STANDBY
/ON
POWER
SYSTEM
or
Front panel Remote control
00_HTR-5790U_EN.book Page 23 Tuesday, December 9, 2003 9:16 AM