Zanussi WASHER-DRYER WJS 1382 - Manual (Page 21)

ENGLISH
21
■
The door will not open:
■
The machine does not dry or the
laundry is not dry enough:
■
The drying time has not been selected.
■ The tap is closed.
■
The drain filter is blocked.
■
A suitable drying time in the correct sector
has not been selected.
■
The drum is overloaded.
■
You have selected option before drying.
If you are unable to identify or solve the
problem, contact our service centre. Before
telephoning, make a note of the model, serial
number and purchase date of your machine: the
Service Centre will require this information.
Mod. ..........
Prod. No. ...........
Ser. No. .........
Mod.
.......... Ser.
P0042
■
The programme is still running.
■ The door lock has not been released.
■
There is water in the drum.
The door can be opened when the door
locked light is off.
■
The machine makes an unusual
noise:
■
The machine is fitted with a commutator
motor which makes an unusual noise
compared with other traditional machines.
This motor enables a softer start to the spin
and controls the increase in spin speed
better. In this way, machine performance is
improved.
■
Water is not visible in the
machine:
■
The machine, which is the result of modern
technology, runs in a very economical way
with low water consumption. Performance is
nevertheless excellent.
■
Spinning starts late or the
machine does not spin: ■ The electronic unbalance detection device
has cut in because the laundry is not evenly
distributed in the drum. The laundry is
redistributed by reverse rotation of the drum.
This may happen several times before the
unbalance disappears and normal spinning
can resume. If, after 10 minutes, the laundry
is still not evenly distributed in the drum, the
machine will not spin. In this case,
redistribute the load manually and reselect
the spin programme.
■
The machine fills then empties
immediately: ■ The end of the drain hose is too low. Refer to
relevant paragraph in “water drainage”
section.